Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

The assembly and debugging work of the device

On March 18th, the functional test of the breathing device was completed, and at the same time, the assembly and debugging of the device were also carried out.

Xiaoyu Liu, Keye Huang, Tinglan Ma, and Drew Yang conducted comprehensive performance tests and parameter verifications on the breathing device, ensuring its stable operation and normal functions. At the same time, they completed the structural setup, component assembly, and overall trial run of the device, successfully completing the two related tests and setup tasks for the device today.

The assembly and debugging work of the device / DMSP Perception 2026 by is licensed under a

Leave a Reply

The assembly and debugging work of the device / DMSP Perception 2026 by is licensed under a
css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel