Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Mark Naylor’s Blog

Mark Naylor’s Blog

I want to know how the Earth works…

Toggle navigation menu Menu

  1. Mark Naylor’s Blog
  2. GeoGeekery
  3. Field Kit Details and Checklist
  4. Field Kit: Raspberry Shake

Field Kit: Raspberry Shake

Initially we started our journey using the Raspberry Shake and learnt a lot.

The majority of this development was carried out by PDRA Calum Cuthill.

We found two major limitations for our application:

  • The use of the raspberry pi was too power hungry
  • The sampling rate was limited to 100 samples per second – which was too low for us

For these reasons, we moved onto developing the Geoduino.

Here we document what we did with the Raspberry Shake

Share

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel