Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Moulds

This first mold is made from silicon and is of the normal/ slight smile face

This mold is made from latex with a plaster armature. This was my first time using latex and although it was a bit of a slow process it is a lot cheaper and has worked just as well as silicon so I’m inclined to continue using it.

Moulds / Isabella Inskip / MA FINE ART 4 STUDIO AND RESEARCH (2020-2021)[YR] by blogadmin is licensed under a Creative Commons Attribution CC BY 3.0

Leave a Reply

Your email address will not be published. Required fields are marked *

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel