Primary Research: Finishing Touches

: Beginning to Weld the pipes on to the standing canister

: Making sure the sculpture doesn’t tip over by adding supports

I finally got a slot in the metal workshop so I could complete my piece! Today I realised the piece may be top heavy and topple over when all put together. So I started welding pipes to secure the canisters before adding supporting pipes so that the weight wasn’t completely focused on the large white canister. I then used an epoxy to stick a bolt on to the smaller white cannister (which turned out to be plastic rather than metal- so I couldn’t weld it!) from which tomorrow I will add a few more pipes to finalise the sculpture.

Dec 1, 2020

Primary Research: Finishing Touches / Hannah Grist / MA FINE ART 4 STUDIO AND RESEARCH (2020-2021)[YR] by blogadmin is licensed under a Creative Commons Attribution CC BY 3.0

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Your name Your email address Please enter an email address you wish to be contacted on. Report description Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

Cancel

Secondary research: Roman Sigmer, Mark Mandes and Chantelle Akerman.

Primary Research: Finishing Piece.

Leave a Reply Cancel reply

Report this page