Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Arduino Grove Sound Sensor Test Record

Test equipment: Arduino Grove sound sensor

Tester: Li Lyu

Test objectives:
1. Test the Grove sound sensor’s data detection response time and optimize its detection speed.
2. Evaluate the sound sensor’s ability to detect breath and sound to determine if it is suitable for subsequent installation interactions.

Test process & Results：The code runs successfully. The serial monitor can display the sound signal data and change with the environment sound.


However, under the current test conditions, the response time of data detection is long and there is a certain delay.
The data fluctuates greatly due to background noise.

Arduino Grove Sound Sensor Test Record / dmsp-process25 by is licensed under a

Leave a Reply

Arduino Grove Sound Sensor Test Record / dmsp-process25 by is licensed under a
css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel