Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

This exercise was all about sketching and drawing. It is my first time to draw so many cuboids with pencils and ruler. And this drawing method requires many lines and point which makes me a little bit confused at first by all the line crossing each other. I drew 12 cuboids in two point perspective, 12 cuboids in three point perspectives and 3 cuboids on a ground line

.

then I choose a cuboids from the cardboard cuboids I have made and did a Rotated plan method of one of my rectilinear volumes.

perspective drawings—week3 / Yuchen Fan / Product Design 1A: Fundamentals (2020-2021)[SEM1] by blogadmin is licensed under a Creative Commons Attribution CC BY 3.0

Posted by s2062297

12th October 2020

Categories

Tags

No tags have been added to this post.

Previous post

product sketches—week3

Next post

rectilinear volume in plastic—week3

Leave a reply

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Your name Your email address Please enter an email address you wish to be contacted on. Report description Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

Cancel