Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

NEWDIA4Planet – MSCA Project

NEWDIA4Planet – MSCA Project

Individual Fellowship project supported by Marie Skłodowska-Curie actions

Toggle navigation menu Menu

  1. NEWDIA4Planet – MSCA Project
  2. NEWDIA4Planet: Research
  3. Work Package 2: System production

Work Package 2: System production

 

The new internal-resistive heaters were fabricated from Re and Pt-Ir alloy thin-foils. The heaters were incorporated into a DAC as designed in WP1, together with an insulated composite gasket, which supports both the sample and the heater(s) between diamond-anvils. The Fellow also established the photolithography process for patterning a thin-film heater on a diamond-anvil, and received training for operation of a thin-film deposition system, which was intended to be used for deposition of Al2O3 insulation layer on a diamond anvil.

 

Microscopic pictures of the Pt-Ir heater with Mg2SiO4 as a sample, taken before (a), during (b), and after (c) heating. The sample is sandwiched between two heaters, enabling double-sided heating.

 

Please leave us comments below!

 

This project has received funding from the European Union’s Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement No. 753858.

 

Copyright Emiko Sugimura-Komabayashi

Leave a reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel