Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Tag: process

Workshop about the installation

Date: 21/03/2025
Venue: Common room of the student residence opposite to ECA.

I would like to record this workshop from my personal point of view.


I prepared a lot of plastic bottles as the main material for this activity.
I broke them into pieces


Through high temperature, they are combined into beautiful shapes.


I was mainly responsible for breaking down the plastic bottles and molding them at high temperature.

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel