Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Arduino and Touchdesigner connection

Arduino and Touch designer connection

Test One
Test time: 02/03/2025
Tester: Can
Test content: Touch designer and Arduino connection
Components used: ultrasonic sensor, Arduino, breadboard, cable.
Test Result: Successful connection and the value on the touch designer has feedback changes.

Test 2
Test time: 04/03/2025
Tester: Can& Li
Test content: Touch designer and Arduino connection
Components used: temperature and humidity sensor, breadboard, cable
Test Result: The connection is successful, but the value of Arduino does not form the value change feedback on TD successfully.

Test 3
Test time: 05/03/2025
Tester: Can& Li
Test content: Touch designer and Arduino connection
Components used: temperature and humidity sensor, breadboard, cable
Test Result: Connection was successful, but the value of Arduino didn’t form the feedback of value change on TD.

To sum up, the result of the whole test phase is unstable, we need to keep debugging the device and form stable and reliable numerical feedback in order to guarantee the normal progress of the project, although we are looking for an alternative plan b, Li and I both hope that we can find out the reason in the continuous trial and error, and successfully achieve the connection.

External help: Joe
Refer to the tutorial:

https://wiki.seeedstudio.com/Grove-TemperatureAndHumidity_Sensor/

https://www.youtube.com/watch?v=4dO7Q5oQbRg

https://www.youtube.com/watch?v=6bT3G4Mep7E

 

Arduino and Touchdesigner connection / dmsp-process25 by is licensed under a

Leave a Reply

Arduino and Touchdesigner connection / dmsp-process25 by is licensed under a
css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel