Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Radar scanning model rendering test (Draft)

Firstly, the original model obtained from the scanning


The following section shows the effect of offline rendering:

Next is the dynamic rendering

Since the test was not done with professional equipment, the detail of the model was definitely not good enough, but both the test and the previous model after scanning with professional equipment were too messy for post-processing the normals at a low cost due to the overly messy uv’s.

Note: Subsequently I tried to import the noise model’s forced direct conversion to fbx or obj format from sketchfab to achieve the perspective effect, but this didn’t work.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel