Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Timber joinery for large buildings using robotic fabrication

Timber joinery for large buildings using robotic fabrication

Research around the use of computer numerical control (CNC) cut joinery to connect elements in timber buildings.

Category: Uncategorised

CNC fabrication facilities at the School of Engineering

This is how we do it… These images give an idea of the process for computer numerical control (CNC) cutting timber joinery into large engineered wood products. Here a dovetail joint is cut with a cross-laminated timber (CLT) mortise and a laminated veneer lumber (LVL) tenon, to create a test specimen to investigate the strength […]

2 July 2025 0

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel