Any views expressed within media held on this service are those of the contributors, should not be taken as approved or endorsed by the University, and do not necessarily reflect the views of the University in respect of any particular issue.

Month: January 2021

image_pdfimage_print

This wasn’t the first time that I have used Rhino CAD to make 3D jewellery and a Medal but it was the first time that I used Rhino to make vessels that will be 3D printed. I also haven’t used Rhino in a while so it was good to get back into the swing of […]

The first Contemporary Silversmith that I researched is called Kathryn Hinton. She is a designer that creates jewellery and silverware in her studio which is situated in Edinburgh. She graduated at Kent Institute of Art and design where she completed BA Hons in Jewellery and silversmithing before she studied a postgrad at Bishopsland. She then […]

These the the photographs of my final design from my ice breaker project of a vessel for piece of fruit. I enjoyed this project as you could interpret the brief the way that you want as a fun exercise. I chose a strawberry as they are my favourite fruit. I drew a template then used […]

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel