Product Design 1B

For our first studio of Product Design 1B we tried to represent different adjectives, such as soft or masculine, with 2D and 3D forms. First we had to…

Submission Post

I submitted my 10 plaster forms, 5 wooden forms, pewter cast, plaster mould, plaster turned object and aluminium cast at 11:46 today (09/12/19). Dec 9, 2019

Summative Post

This is a summative post on what I’ve learnt through this course. I’ve really enjoyed this course, and felt I’ve learnt a lot. I really enjoyed working with…

Perspective Drawing

To get to grips with two point perspective we had to draw 12 cubes, shading each face to indicate clearly which was which. We also had to create…

Finishing Aluminium Cast

After pouring the aluminium and making the cast there was still a lot to do to get to a finished pendulum. The first thing was to remove all…

Aluminium Cast

To start with we removed the cast moulds from the kiln where they’d been firing. We then set them into the sand pit and packed sand around the…

Subtractive Sketching

To experiment with perspective drawing and negative space, we had to draw out 20 cubes in 2 point perspective, all with various different elements removed. We then had…

Mould Making

In order to do an aluminium cast, we needed to create a mould that could withstand molten metal, which a plaster mould could not. To do this, we…

Wax Cast

For the next part of our pendulum brief we had to make a wax cast, which we would then use to make the aluminium cast. I first soaked…

Iterative Sketches

For this brief we had to pick an object from the National Museum of Scotland, draw it to get familiar with the shape, and then produce iterative sketches…

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel