James Grossman / Computer-Aided Design (2020-2021)[SEM1]

James Grossman / Computer-Aided Design (2020-2021)[SEM1]

  1. James Grossman / Computer-Aided Design (2020-2021)[SEM1]
  2. 2020
  3. December

Month: December 2020

Week 12

I started off this week experiemting with creating pieces of furniture in Fusion 360, I created some really intriguing peices such as a wall piece, a coffee table and even an outdoor chair. The wall art consists of a geoemtric panel which has these triangular latices attached to one another. The coffee table is rather […]

8th December 2020 0

Week 11

I redrew the whole autocad file again, this took a lot longer then I would of liked it to take, I though it would of taken an hour or so but it took around 5 hours as I had to also add in additional features like dimensions and a title block. By redoing the CAD […]

8th December 2020 0

css.php

Report this page

To report inappropriate content on this page, please use the form below. Upon receiving your report, we will be in touch as per the Take Down Policy of the service.

Please note that personal data collected through this form is used and stored for the purposes of processing this report and communication with you.

If you are unable to report a concern about content via this form please contact the Service Owner.

Please enter an email address you wish to be contacted on. Please describe the unacceptable content in sufficient detail to allow us to locate it, and why you consider it to be unacceptable.
By submitting this report, you accept that it is accurate and that fraudulent or nuisance complaints may result in action by the University.

  Cancel